Best Garage in Dallas to Repair Your Jaguar’s Damaged Ignition Coil

Posted on | 26 Jan 2020 By Anita Gaal

The ignition coil, also known as the spark coil, is a small, compact electric transformer. It has the responsibility of taking power from the battery or generator and sending it to the spark plugs. In more formal terms, the ignition coil takes the low voltage from the battery and transforms it into much stronger voltage. This increased voltage creates the electric surge needed by the spark plugs to ignite the fuel. Without this component, you would experience decreased gas mileage as well as improper acceleration in your Jaguar.

Signs of a Bad or Malfunctioning Ignition Coil

There are several symptoms that may arise when the ignition coil goes bad in your automobile. While some of these may relate to other mechanical issues, it is vitally important to have your Jaguar diagnosed by an expert automotive repair shop. However, spark coil malfunctions will often result in one of the following consequences.

One of the most common signs of a coil malfunction is when the engine is hard to start, especially during cold weather. You might find that the motor is having a difficult time cranking or turning over. Your vehicle may stall at inconvenient times as well. A damaged coil could send irregular voltage or sparks to the plugs, thus causing the engine to completely shut off when your automobile comes to a stop.

The distinctive and startling sound of a car backfiring can also be the result of a faulty coil. If it fails in the early stages, it may leave fuel in the combustion cylinders. This unused fuel will abruptly exit through the exhaust pipes and end up costing a significant amount of money in repairs. Your engine may also misfire when there is an ignition breakdown. As you reach high speeds, you may hear a sputtering sound or feel the steering wheel jerk. It could also vibrate when sitting at a stop light or when the motor is idling.

Poor fuel economy is another red flag that signals an issue. As less power is transported to the spark plugs, the engine will utilize more fuel to compensate for the reduction. This compensation means less miles to the gallon in fuel economy. Your Jaguar may also fall victim to an increase of dangerous emissions. Bad coils can result in higher hydrocarbon emissions. If this happens, your vehicle will fail a state emissions inspection.

The check engine light alert sensor is one of the first indicators that you have a problem. While many mechanical issues can cause the sensor to illuminate, a bad spark coil is sure to trigger the alert. If the check engine light comes on in your Jaguar, you should seek diagnosis and service as soon as possible.

Euro Automotive is Ready to Service Your Jaguar

Whether it is a potential ignition coil malfunction or it is simply time for regularly scheduled maintenance, our team at Euro Automotive is here for you! We have been in business for over 18 years and specialize in European auto service and repair. We are conveniently located and accessible to residents of Dallas, Garland, Arlington, and Fort Worth, TX.

We understand the intricacies of your Jaguar and the mechanics that keep it performing at its best. Our highly-experienced, factory-trained, and certified technicians use OEM parts to make any necessary repairs. Euro Automotive offers an extensive and comprehensive list of model specific services for Jaguar, and we can save you up to 25% off the dealership’s prices. We have a reputation for quality and service. We are accredited by the Better Business Bureau and our technicians are BOSCH certified.

Our commitment shows, as we want to build a working relationship with each customer that visits our shop. We back our services with a 12-month parts guarantee, 90-day guarantee on labor, as well as a 12-month/12,000-mile warranty. Free diagnosis is always available, and we utilize six full-service bays to ensure timely repairs. Trust your Jaguar to the team that has been providing unsurpassed service for European automobiles for over two decades. Contact us today by phone or come by to speak with one of our skilled technicians.

How to Fix Suspension Problems in Your Audi A4

Posted on | 9 Jan 2020 By Anita Gaal

The most common suspension issue that most Audi A4 drivers experience is noise coming from the suspension. Your suspension should always work silently, and any fault should be seen as a sign of failure. Typically, suspension noises are actually a result of other parts failures and are often the first indicator that drivers have that their Audi is dealing with a suspension issue. In this article, we’ll be addressing some of the most common causes of suspension problems in your A4 as well as some tips and tricks for home repairs, should you wish to tinker.

Basic Supplies You’ll Need

Before undergoing any type of repairs, you should make sure you have the supplies you need. For suspension issues, alongside specified supplies you’ll need:

• Ratchet set
• Jack and jack stand
• Torx set
• Flashlight

Problem 1: Dry CV Joints

Constant Velocity (CV) joints are part of the axles and are surrounded by thick rubber that keep them well oiled. However, with time and use, the rubber shielding can break and leak, leaving the joints dry and prone to failure. When this happens, they will click loudly and will only become louder when making corners. To check the health of your CV joints you should:

• Unscrew the lug nuts and jack up your vehicle (making sure it’s secure).
• Remove the wheel you suspect the squeaking is located behind.
• Check under your vehicle with your flashlight, locating each joint and checking the rubber for tears or damages. Squeeze the rubber too to ensure there aren’t leaks!
• Next, rotate the wheel and check for noises. If you’ve located the problem, then you’ll need to replace the CV joint.

Special tools are required for this type of repair, such as a breaker bar and an impact gun. This should only be completed by an experienced home mechanic or an expert at a professional garage.

Problem 2: Failed Bushings

Audi A4 uses control arms in a multilink design with each control arm having a ball joint and bushing, which can fail and result in noises. Bushing failure results in a noise that can be heard as a creaking noise or clunk when driving over bumps. To check the status of your bushing you should:

• Raise the car from the ground using your jack and find the control arm which you suspect is at fault.
• Move the control arm manually and check if it is loose.
• Have a friend bounce the car up and down so you can hear any noises.

Replacing ball joints and control arms is easier that CV joints, but it does need special tools called a ball joint puller that has many types. This is able to be rented from many auto stores. Lubricant may also be needed to loosen bolts.

Reason 3: Leaking or Failed Shocks

The shocks have oil that runs through apertures inside them. This dampens the motion from suspensions, and when they fail, you will feel much more of the impact from the road. Failure of the shocks can also cause slamming noises. To check the shocks you can:

• Raise up the car with a jack, remove the wheel, and visually inspect the shocks.
  Or
• Press on one corner of your car and see how it settles back. If it bounces excessively or jerks instead of raising smoothly, then it is likely that you shocks or even your suspension springs may be faulty.

You will need specialist tools to fix shocks, such as a spring compressor and a ball point puller, and this repair job may be better left to the professionals!

DIY Repairs: Worth the risk?

While there’s no harm in diagnosing suspension issues yourself, when it comes to undertaking repairs, you need to ask yourself whether it is worth attempting yourself or instead seeking professional aid. DIY repairs can be a risk, as you may not be clued up on auto safety procedures, meaning injuries are more likely. You also may not know how to handle the different components. This can result in unsuccessful repairs. Also, DIY repairs can sometimes cost more than professional work, due to the renting or purchasing of tools and your own time and labor.

The Professionals: Euro Automotive

If you’re in any doubt as to how to fix your Audi A4, then you should call the experts at Euro Automotive. Our professional, friendly team at Euro Automotive of Dallas, Garland, Arlington, and Fort Worth, TX will guarantee successful and thorough repairs. You can drive away in your Audi with confidence. Let us become your trusted Audi service and maintenance shop today.